Solaris rescan SCSI device on VMware 
Wednesday, July 22, 2015, 20:32 - Oracle Solaris, VMware
Posted by Administrator
If you want to add a SCSI device on a VMware virtual maschine which is running Solaris you normally just have to use the following command to see the new device
devfsadm

If you do not see the disk from Solaris then you just have to use the following commands: 
root@xxxxx # cfgadm -al
Ap_Id                          Type         Receptacle   Occupant    
Condition
c1                             scsi-bus     connected    configured   unknown
c1::dsk/c1t0d0                 disk         connected    configured   unknown
c1::dsk/c1t1d0                 disk         connected    configured   unknown
c1::dsk/c1t2d0                 disk         connected    configured   unknown
c1::dsk/c1t3d0                 disk         connected    configured   unknown
pcie160                        etherne/hp   connected    configured   ok
..
..
pcie263                        unknown      empty        unconfigured unknown
root@xxxxx # cfgadm -x reset_all c1
root@xxxxx # devfsadm
root@xxxxx # cfgadm -al
Ap_Id                          Type         Receptacle   Occupant    
Condition
c1                             scsi-bus     connected    configured   unknown
c1::dsk/c1t0d0                 disk         connected    configured   unknown
c1::dsk/c1t1d0                 disk         connected    configured   unknown
c1::dsk/c1t2d0                 disk         connected    configured   unknown
c1::dsk/c1t3d0                 disk         connected    configured   unknown
c1::dsk/c1t4d0                 disk         connected    configured   unknown
pcie160                        etherne/hp   connected    configured   ok
...



[ view entry ] ( 143 views )   |  permalink  |  print article  |   ( 3 / 4442 )

<Back | 1 | 2 | 3 | Next> Last>>